Home/Tech & Practice

How it works

TRABOLD-filtern statt Öl wechseln

The filter runs alongside the normal oil filter. It removes the finest dirt and water from the oil and cools it through its housing. So the oil stays good, and the usual oil change is no longer needed.

Original: Datenblatt, 2011

TRABOLD filter, side view

In five steps

The oil’s path through the filter

Originale: Datenblatt, 2011 · Vorzüge, 2001

To scale

Down to 0.1 micron

That is a ten-thousandth of a millimetre, up to 200 times finer than usual filters. The top line is a hair. You can barely see the last one.

  • Hair, approx. 70 µm
  • Standard filter, 20 to 40 µm
  • Pollen, approx. 10 µm
  • TRABOLD, Mittelbereich, 1 µm
  • TRABOLD, bis 0,1 µm

Original: Datenblatt, 2011 (0,1 µm und 1 µm). Haar, Pollen und Standardfilter sind allgemeine Vergleichswerte, nicht vom Hersteller.

From the patent

The design in section

Drei Teile: das Gehäuse, der Einsatz zum Wechseln und die Anschlüsse. Klicken oder tippen Sie auf die Punkte im Bild.

In detail
According to the manufacturer, it is the first fine oil filter that filters radially and axially, meaning from outside and from above. The insert is built for tension instead of compression, so it withstands high pressure. Hermann Trabold received two patents for this in 1991 and 1994.
All patents

The principle

Two filters, two jobs

The normal filter stays in and takes the large oil flow. The TRABOLD filter cleans only a little at a time, but very finely. Over time, all the oil passes through.

20 bis 40 µm

Normal oil filter

Lots of oil, coarse filter: 20 to 40 µm. According to the manufacturer, it only needs replacing every 100,000 km.

bis 0,1 µm

TRABOLD filter

Little oil, very fine filter: on the 10er, 1 to 5 litres per minute, dirt down to 0.1 µm.

Originale: Vorzüge, 2001 · Datenblatt, 2011

The longer it is filtered, the better

Why engine oil still stays black

Hermann Trabold showed it in public: black transformer oil turns clean and golden yellow again after a few minutes in the filter. Engine oil, on the other hand, stays black. You can’t see that it is clean. You measure that in the lab.

In detail
According to the manufacturer, the black is ultra-fine carbon, a very good lubricant. The filter holds back the coarse particles that cause wear. It lets the very finest through. In the field test this oil lubricated better than fresh oil.

From the archive

The benefits at a glance

  • Oil change

    Fällt weg. Stattdessen kommt alle 15.000 bis 50.000 km ein neuer Einsatz.

  • Fresh oil

    Up to approx. 85 % lower costs through less new oil.

  • Engine type

    Not tied to one engine. On the 10er, not even half a litre of extra oil is added.

  • Water

    The insert soaks water out of the oil. Without water, oil does not turn acidic.

  • Cooling

    The fins protect the oil from overheating.

  • Pressure

    The housing withstands 20 bar continuously.

  • Reuse

    You can remove the filter and take it to your next vehicle.

  • Disposal

    The insert is mainly paper. But it does not belong in household waste. It goes to a collection point.

  • Payback

    In 2001 the manufacturer expected this at the 4th to 5th oil change for cars.

Angaben des Herstellers. Wird das Öl zu dick oder zu dünn, überhitzt es oder gerät etwas hinein, muss es trotzdem gewechselt werden. Originale: Vorzüge, 2001 · Filterung und Ölpflege, 1998 · Startseite, 2001 · Geschäftsbedingungen von 1998